4” Router Dustport is a combination of the 4” to 2-1/2” reducer and the right angle router dustport. The small end on the 4” to 2-1/2” reducer fits perfectly inside the right angle port so you can then attach a 4” hose to the larger end of the reducer with a hose clamp. This unit will fit on just about any router table fence system.

2½” Extended Dust port directly accepts a standard 2¼” Shop-Vac® hose end in the dust port opening. No hose clamp is required for this type of connection. You can easily attach a standard 2-1/2” dust collection hose around the outside of the extended dust port opening with A single hose clamp. The fitting itself attaches to the back of most router fences.

2½” Low Profile Dustport directly accepts a standard 2¼” Shop-Vac® hose end in the dustport opening. You can also attach a standard 2-1/2” dust collection hose around the outside of the dustport opening with a single hose clamp. The fitting itself attaches to the back of most router fences with two standard wood screws. The low profile makes this fitting an excellent add-on to any drill press fence system.

2½” Router / Bandsaw Dust Port is one of the most popular fittings used in creating an airway on you router table, bandsaw or any other machine that does not come with a dustport. Attaches with 4 screws (not included) on each corner. The dustport will accept a 2-1/2” hose. A hose clamp is required for this type of connection. This fitting will also accept a standard 2¼” Shop-Vac® hose end, no hose clamp is required for this type of connection.

4” Dustport can be used on machines with 4” openings, such as bandsaws and joiners. Attaches with 2 screws (not included) at the top and bottom. The dust port accepts 4” hose. A hose clamp is required for proper connection

4” Flat End Elbow Dust Port Is a great fitting that is fastened directly to your machine when space is limited around the machine. There is no need for all the extra little connector pieces with this one! A hose clamp is required on one end for proper connection.